1/11/2024 0 Comments Replacing gfci outlet![]() If the outlet tester reads "hot/ground reverse", switch the positions of the hot and ground wires on the outlet.If the outlet tester reads "hot/neutral reverse", switch the positions of the hot and neutral wires on the outlet.If the outlet tester reads "open neutral", connect the neutral wire (white) to the neutral screw.If the outlet tester reads "open hot", connect the hot wire (red or black, unless re-identified) to the hot screw. ![]() If your home does not have grounding wires, you should replace the outlet with either a two-prong outlet or a GFCI outlet. If the outlet tester reads "open ground", connect the grounding wire (green or bare) to the green grounding screw.These can be purchased at your local hardware store, and usually cost between five and ten dollars. A better way to test an outlet is to use an electrical outlet tester. Use an small electrical appliance or one that won't draw too much power (such as a television set, computer system or mobile device), but be careful as open areas are now live. It does not matter which wire of a colored pair goes to which screw unless the outlet is controlled by a switch. There may be one, two or more sets of wires connected to your outlet, depending on its location in the circuit.The bare-copper or green wire will connect to the green ground screw attached to one of the outlet mounting brackets.The "neutral" white wires should be connected to the side that the taller plug slot is on and generally have silver screws.The "hot" (usually black or red) wires should be connected to the side that the shorter plug slot is on and generally have gold colored screws.Use the same mark for each wire connected to the same terminal screw of the device. Label the wires with some sort of identifying mark on masking tape wrapped around each wire. If the outlet in the room isn't protected by circuit breakers, but by fuses, make sure that fuse has been removed.Standard outlets are usually connected to 15 and 20 amp circuits breakers. If you leave the light fixtures on, it gives you better lighting to work on the plugs and switches. The light fixtures are usually on the lower value amp circuit breakers (usually 15 amps).A voltage detector ("power sniffer") is also useful for detecting voltage. This will shut down the entire house, but it is better to be safe than to risk electric shock. If the outlet doesn't function at all, and you are not sure which breaker turns it off, then you may want to turn off the main breaker.X Research source X Expert Source Daniel Stoescu If the device isn't working, find a different method to determine the power is off. You should plug a lamp (test it first) into the outlet that you intend to change and then turn off the circuit breaker to make the lamp go off. Make certain that the electricity is turned off to the circuit that you are working on.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |